Browse by title articles:

Building a BMX Bunny Hop Trainer

by Ivan Gotta Crotchful    

2-2"x4"x3'board

1-1/2"x8' piece of hard plastic water pipe.

20-2" finish nails.

1-3/4"x1'x4' plywood

4-3"deck screws

With the materials assemble as the diagram illustrates.

"You can see the detailed picture at www.evilbmx.biz under articles page".

The 3" deck screws come up from the bottom of the plywood into the 2"x4"x3' boards.

The finishing nails are nailed into the board about ½" to ¾" The nails provide a place for the plastic pipe to hang. You can put the nails 1" apart going up on each side.

Using the Bunny Hop Trainer.

Set the trainer in the middle of the area you are going practice. Set the pipe on the lowest nail to get use to it. Start from the opposite side where the pipe hangs and ride towards the pipe and hop over it. If you hit the pipe it will simply fall off the hanger. When you clear the pipe with ease raise it another 1".

You will find after using the Bunny Hop Trainer your grinding and stalls will be easier at the Skate Park or street riding. You can amaze your BMX and skateboarding hombres with your new learned skills.


-----------------
Ivan Crotchful is a BMX flatlander who contributes articles to EVILBMX. He claimed to be a nymphomaniac until he found out what it really meant. He use to listen to a punk band called The Nymrods and he thought a nympho was a band groupie. You can read this article and others at www.evilbmx.biz.